Kitchen Island Builders
Hob and Extraction Installation
Induction, gas or downdraft hobs fitted into the island with ceiling-mounted, recessed or downdraft extraction ducted outside.

What's involved
Putting a hob in an island means solving extraction. Options are an island chimney hood fixed to the ceiling, a flush ceiling extractor recessed between joists, or a downdraft unit that rises from the worktop. Ducting ideally runs to an outside wall: through the ceiling void for a hood, or under the floor for a downdraft. Recirculating carbon filters are possible but less effective at removing moisture. Downdraft units take up most of the cupboard beneath, so storage is lost. A gas hob must be connected by a Gas Safe registered engineer, and induction hobs need a dedicated circuit. Most islands also need a heat-resistant worktop edge and clearance from seating. Allow a day to fit the hood and duct. You must confirm ceiling joist direction, as it decides whether a recessed extractor fits.
How we handle it
Tell us about your kitchen
Use the quote form to give us the room size, the island you have in mind and whether it needs water, power or a hob. Photos of the space and floor help us match you with the right specialist.
Survey and design
A local joiner or fitter visits to measure, check clearances and floor construction, and confirm where services can run. You agree a layout, materials and finish, and receive a fixed written price.
First fix services
Before the island is built, pipes and cables are run under the floor to the island position. Floors are made good so the carcass can sit on a flat, solid base.
Build and fix down
The carcass is assembled, levelled and fixed to the floor. Doors, drawers, end panels and plinths go on, and the worktop is templated or fitted the same day for timber and laminate.
Worktop, connections and handover
Stone tops are fitted, the sink, hob and sockets are connected and tested, and certificates are handed over. The fitter checks every door and drawer lines up before leaving.
Price guide
Island prices depend mainly on size, how the carcass is made, the worktop material and whether services are needed. A plain storage island with a laminate top costs a fraction of a stone-topped island with a sink and hob. We give a fixed price after a survey so you know exactly what is included before any work begins.
- Large bespoke island: from £7,000. Made-to-measure carcass, painted or veneered finish, stone worktop and integrated storage.
- Medium island with seating overhang: £2,800–£5,500. Up to 2.2 metres with quartz or oak top and a seating side for two to three stools.
- Small storage island, laminate top: £1,200–£2,500. Around 1.2 to 1.5 metres long using standard units, fitted and fixed to the floor.
Questions about hob and extraction installation
Can you put a sink in a kitchen island?
Yes, but the waste pipe must fall to a drain, which is the main challenge. On a timber floor the plumber runs pipes between joists. On concrete, the floor is chased out and repaired. If no fall is possible, a small pump can lift waste to the drain. Agree the sink position before building, because moving it later means lifting the floor again.
Can you build a kitchen island on underfloor heating?
Yes, but the heating pipe layout must be known before fixing. Ideally the island area has no heating loops beneath it, as covered floor wastes heat and can overheat units. Where pipes run under the island, fitters use shallow fixings or adhesive bonding. Services for the island should be planned before the screed is poured on new builds.
How long does it take to build a kitchen island?
On site, most islands take two to four days to build, plus a day for first fix plumbing and electrics beforehand. Stone worktops are templated once the carcass is fixed and fitted seven to ten working days later. Bespoke painted islands add one to three weeks of workshop time before installation, so the whole project often runs three to five weeks.
Other services
Bespoke Island Construction
Fully made-to-measure islands built from birch ply or MDF carcasses, sized to your room and finished in paint, veneer or laminate.
Island From Existing Kitchen Range
Islands assembled from standard units matching your current kitchen, with end panels, plinths and a new or matching worktop.
Sink and Plumbing for Islands
Running hot, cold and waste to an island sink or dishwasher, including under-floor routes and pumped waste where gravity will not work.
Electrics and Sockets
Pop-up sockets, side-mounted outlets, USB points, hob circuits and lighting supplies installed by a qualified electrician.
Worktops and Breakfast Bars
Quartz, granite, solid wood and laminate island tops, including seating overhangs, waterfall ends and raised bar levels.
Hob and Extraction Installation near you
Get a free kitchen island builders quote
Tell us what you need and we'll come back with a clear price.
Request a quote